Creating the eye was done in a similar way to the creationg of the blow hole. once i had the polygon for the eye positioned where i wanted it, i used the inset tool and delete the polygon within that. And in the same way as the blow hole i held down the shift key and moved the eye in. The sphere was added as an eye for the dolphin. Once the eye was complete the dolphin was ready for texturing.
The blow hole was created by connecting edges together on the top of the dolthin, Once i was happy with the position of the blow hole i deleted the polygon, selecting the endges of the hole and creating new polygons going down by holding shift.
The nose if the dolphin was then extruded out to match the shape shown on the side image, this was done by once again using the scale tool.
The front fins where then extruded out and shaped as to the bottom image.
Once i had shaped the dolphin, i selected the polygons on one half of the model and deleted them. i then attached a symerty modifier to the dolphin. I used the extude tool to create the dorsal fin and the tail fin. Shaping them by selcting the veticies and moving them to match the bottom image.
Converting the Cylinder into an editable polygon i used the scale tool and selected all the veticies on each coloum and scaled the to match my guidence image at the back. I did this also in the to view to get the general shape of the dolphin.
Using the base images and the side image i created a cylinder that matched the length of the folthin and i made it slightly taller and wider.
No comments:
Post a Comment